Monstercolors Black Bitumen Tar-Cote Spray Paint | 1, 2, 3, 4 Multi-Pack Bundle

For optimal performance and durability, follow these professional-grade application steps.

1. Surface Preparation
Clean: Ensure the surface is free from loose rust, dirt, grease, oil, and peeling paint. Use a stiff wire brush or degreaser where necessary.

Dry: The surface must be completely dry before application to ensure maximum adhesion and to prevent trapping moisture.

Masking: Mask off any surrounding areas you do not wish to coat to prevent overspray.

2. Product Preparation
Agitation: This is a high-solids, heavy-duty product. Shake the aerosol vigorously for at least 5 minutes after the mixing ball begins to rattle. Failure to do so may result in uneven flow or clogging.

Ambient Conditions: For best results, apply in dry conditions with an ambient temperature between 10°C and 25°C. Avoid application in direct, intense sunlight or high humidity.

3. Application
Distance: Hold the aerosol 20–30 cm from the surface.

Technique: Apply in steady, overlapping passes. To achieve the required "coverall" thickness, apply in multiple thin coats rather than one heavy layer, allowing for adequate flash-off time between coats.

Coverage: Ensure all crevices, joints, and exposed edges are thoroughly covered, as these are the primary points of potential water ingress.

4. Curing & Maintenance
Drying Time: The film will be touch-dry quickly but requires time to fully cure into its flexible, weather-resistant state. Avoid subjecting the coating to mechanical stress or high-pressure washing for at least 24–48 hours.

Equipment Cleanup: After use, invert the can and spray for a few seconds to clear the nozzle and prevent the bitumen from hardening inside the valve.

Pro-Tip: Given its versatility, Monstercolors Bitumen Tar-Cote is ideal for protecting high-wear areas on automotive chassis, wooden fence posts in constant contact with soil, and the exterior of marine-grade storage containers.

Monstercolors Bitumen Tar-Cote is a professional-grade, high-performance bituminous solution. Engineered for extreme durability, this heavy-duty "coverall" black coating creates an impenetrable, flexible barrier against moisture, corrosion, and environmental degradation.

Technical Properties

Finish: Durable, flexible "off-gloss" black

Surface Compatibility: Multi-surface adhesion to metal, wood, asphalt, concrete, and masonry

Chemical Resistance: Highly resistant to low-level acids, alkalis, and prolonged oxidation

Protection Type: Corrosion-resistant, heavy-duty weatherproofing barrier

Application Method: Professional-grade aerosol delivery system

Primary Applications: Automotive underseal, marine vessel protection, wooden outbuildings, sheds, storage containers, gates, and fence posts

Application Instructions

Preparation: Ensure the surface is clean, dry, and free from loose rust, grease, or debris. Remove any flaking material with a wire brush.

Agitation: Due to the high-solids, heavy-duty nature of this bitumen, you must shake the aerosol vigorously for at least 5 minutes after the mixing ball begins to rattle.

Application: Hold the canister 20–30 cm from the surface. Apply in steady, overlapping passes to achieve a consistent build. For maximum protection, use a "coat-on-coat" technique, allowing sufficient flash-off time between layers.

Nozzle Maintenance: To prevent valve clogging, always invert the can and spray for a few seconds after each use to clear the nozzle.

Curing: Allow 24–48 hours for the coating to reach full cure before subjecting the surface to high-pressure water or mechanical stress.

Important Usage Note
This product is designed for extreme duty; thorough mixing is essential for performance. Ensure ambient temperatures are between 10°C and 25°C for optimal flow and drying characteristics.