Kings Army Spray Paint & White Primer Set | Original Colours

King's Army Industrial Paint: Application Guide

1. Surface Preparation
Ensure the surface is clean, dry, and free from grease, oil, and rust. For best results, degrease the area thoroughly using a panel wipe or solvent cleaner.

2. Priming Requirements
King’s Army Industrial Paint is self-priming and designed for direct application to most surfaces, including wood and previously painted items. However, for non-ferrous metals such as Aluminium, Brass, Copper, or Galvanised Steel, we strongly recommend the use of our Etch Primer to ensure a permanent bond. While a primer is not strictly necessary for every job, its use will always produce a more durable, professional finish.

3. Preparation & Shaking
Shake the can vigorously for at least 2 minutes after the mixing ball begins to rattle. This is critical for industrial Alkyd paints to ensure the high-solid matte pigments are fully agitated for a consistent finish.

4. Application Technique
Hold the can 20–30cm from the surface. Apply 2–3 thin, even coats rather than one heavy coat. The unique fan-spray actuator provides a professional spray-gun pattern; use a 50% overlap on each pass for even coverage.

5. Drying Times

Flash Off: 10–15 minutes between coats.

Weatherproof: Structure can be exposed to rain/harsh conditions after 30 minutes.

Touch Dry: 20–30 minutes.

Hard Dry: 24 hours (full cure).

6. After Use
To prevent nozzle blockages, turn the can upside down and spray for 2 seconds until only clear gas emerges. This clears the valve for future use.
How to use: Ensure the surface is clean and dry. Shake the can for 2 minutes before use to ensure uniformity. Apply with an even motion, from a distance of 20 - 25 cm.Coverage:400ml aerosol, which will cover around 4-6 square feet. (Estimation)

Paint Your Military Vehicle, Airsoft Weapon, War Gear, Military Models & More With King's Army Industrial Paint.

Please Refer To Our colour Swatch Picture To Ensure You Have The Correct Choice Of Colour /. This Is As Close A Match As We Can Achieve To The Actual Colour Of The Paint /. If in doubt, don't hesitate to get in touch with us. We Will Be Happy To Help!

Please note that if intending to use on areas where paint will come into contact with fuel, please use our military 1k cellulose paint.

Technical Specifications: King's Army Industrial Paint

Product Type: High-Solids Quick Air Drying (QAD) Alkyd Enamel.

Finish: Full Matt (Low-Reflectivity).

Container Size: 400ml Aerosol.

Coverage: Approximately 1.5m² – 2.0m² per can (depending on surface porosity).

Temperature Resistance: Intermittent heat resistance up to 120°C.

Chemical & Fluid Resistance: Excellent resistance to grease, engine oils, and general grime. Resistant to occasional fuel splashes if wiped clean immediately. (For high-frequency fuel contact, we recommend our Cellulose Military Range).

Key Features:

Anti-Corrosive: Formulated with protective pigments to inhibit rust.

Rapid Cure: Advanced resin system allows for fast handling times and "all-weather" application.

Single-Coat Capability: High-opacity formula provides excellent hiding power.

Environmental Conditions:
Recommended application temperature between 10°C and 25°C. For best results, avoid painting in high humidity or extremely cold conditions.

Storage: Store in a cool, dry place. Shelf life is approximately 2 years when stored correctly.