Monster Premiere Light Fast Wood Stain – Professional 400ml Alcohol-Based Spray

To create a guide that applies to all variations (like the Mahogany shown in your screenshot), you should focus on the system process rather than the specific colour. Since this is an alcohol-based stain, the key is the preparation and the mandatory clear-coat seal.

Here is the content for your Application and Tech Spec tabs:

Application Guide
Surface Preparation:
For professional results, wood surfaces must be clean, dry, and free from old waxes, oils, or previous coatings. For optimum adhesion and a flawless finish, we strongly recommend cleaning the wood surface thoroughly with Monstercolors Degreaser to remove any hidden contaminants before staining.

Aerosol Application:

Preparation: Shake the can vigorously for at least two minutes once the mixing ball begins to rattle.

Test Spray: Always perform a test spray on an inconspicuous area or a scrap piece of the same wood to check the colour depth and substrate compatibility.

Spraying: Hold the can 20–25cm from the surface. Apply in light, even "cross-coats" (horizontal then vertical). The fan spray nozzle is designed for a smooth, brush-mark-free finish.

Coats: Apply 1 coat for a natural look or a minimum of 2 coats for a deeper, more intense colour. Allow 10–15 minutes between coats.

Sealing (Mandatory): Once the final coat of stain is dry, the surface must be sealed with a clear lacquer (Matt, Satin, or Gloss) to protect the colour and provide durability.

Drying Times:

Touch Dry: 5–10 minutes.

Ready for Topcoat: 20–30 minutes.

Full Hard Cure: 24 hours (at 20°C).

Product Type: Professional Alcohol-Based Light-Fast Wood Stain

Format: 400ml Aerosol

Nozzle Type: High-output Fan Spray

Pigment Type: Light-fast (UV resistant to prevent fading)

Substrates: All wooden surfaces, furniture, kitchen cupboards, marine trims, and flooring.

Coverage: Approx. 3m² per can (1 coat) or 1.5m² (2 coats).

Properties: Non-grain-raising, rapid drying, high-clarity grain definition.

Safety: Solvent-based. Protective mask and goggles should be worn; use only in well-ventilated areas.

System Requirement: Must be over-coated with a clear lacquer for protection.